Practical guide · roof math

How to measure a hip roof

Hip roofs look harder to measure than gable roofs, but when every plane has the same pitch the area works the same way. The extra work is the hips themselves, which drive ridge cap and waste.

Short answer

To measure a hip roof with one pitch, multiply the plan area (including overhangs) by the pitch multiplier to get roof area, then find each hip's length by multiplying the run (half the building's short side) by the hip factor: √(rise² + 288) ÷ 12, which is 1.5 at 6/12. On a rectangular hip roof the ridge equals the long side minus the short side. Use about 15 percent shingle waste for the hip cuts.

Area: the same rule as any one-pitch roof

When all the planes share one pitch, roof area is the plan area times the pitch multiplier, no matter how many hips there are. Measure the outline including overhangs, multiply length by width, then apply the multiplier from the pitch table.

Hips and ridge

Each hip runs diagonally from a corner to the ridge. Its length is the run times the hip factor, where the run is half the short side of the building. On a rectangular hip roof the ridge is the long side minus the short side; on a square roof there is no ridge and the hips meet at a point.

Hip and valley factors by pitch
PitchPitch multiplierHip or valley factor
2/121.0141.424
3/121.0311.436
4/121.0541.453
5/121.0831.474
6/121.1181.500
7/121.1581.530
8/121.2021.563
9/121.2501.601
10/121.3021.641
11/121.3571.685
12/121.4141.732

Worked example: 40 × 30 ft hip roof at 6/12

Plan area is 40 × 30 = 1,200 sq ft. Roof area is 1,200 × 1.118 = 1,341.6 sq ft, or 13.42 squares.

The run is 30 ÷ 2 = 15 ft, so each hip is 15 × 1.5 = 22.5 ft and the four hips total 90 ft. The ridge is 40 − 30 = 10 ft, so hip and ridge cap covers 100 ft. The eaves run the whole perimeter: 140 ft, with no rakes.

With 15 percent waste that is 15.43 squares: order 16 squares, or 47 bundles at three bundles per square.

When the shortcut does not apply

Mixed pitches, dormers, bump-outs and irregular corners break the one-pitch rule. Measure each section separately and add them up, or trace each plane on imagery so every facet carries its own pitch.

Frequently asked questions

How much waste for a hip roof?

About 12 to 15 percent is a common starting point, more on cut-up roofs. Adjust for the product and your crew.

Is a valley the same length as a hip?

For two planes of the same pitch meeting at a right angle, yes: the same factor applies to valleys.

Do hip roofs have rakes?

A simple hip roof has none: every edge is an eave, which means more drip edge and starter along the eaves.

Last reviewed October 27, 2026. Prices and product details change; check current terms before buying. This guide is not engineering, insurance, safety or construction advice.